DenTek Temporary Filling Material is designed to repair lost fillings with the same ingredients dentists use. This is a temporary remedy meant to replace a lost filling or inlay until you have a chance to visit your dentist. Can be used to repair lost fillings or loose crowns, caps or inlays.
To replace a lost filling: Wash the cavity area with warm water and dry with the cotton swab. Use applicator or your finger to scoop a small amount of Temparin from the vial. Pack tightly into the cavity area. Close your teeth together, as if you were biting down on a piece of paper, and chew or grind a couple of times to create a comfortable bite. Use the cotton swab to remove excess Temparin from around the area. Temparin will set softly in your mouth within a few minutes. Avoid chewing on the repair for an hour to allow the material to set. To secure loose crowns, caps, or inlays: Try the crown or inlay first to see if you can fit it accurately back on to the tooth surface. If you are not able to do so, then do not proceed further. If the crown has a post attached to it or if there is tooth surface remaining inside the crown, Temparin may not adhere. Carefully rinse the tooth area and the inside of the crown, cap or inlay with warm water and dry thoroughly with the cotton swab. Scoop a small amount of Temparin from the vial and place evenly inside the crown, cap or inlay. Place the crown, cap or inlay on the tooth and bite down, applying pressure to push into position. Temparin will begin to harden within a few minutes, but will not completely set for an hour. Use a toothbrush to gently clear any excess material from around the crown, cap or inlay. Avoid chewing on the repair for an hour to allow the material to set.
Calcium Sulfate, Paraffin, Zinc Oxide Powder, Potassium Aluminum, Aluminum Sulfate, Aluminum Phosphate, Eugenol, Menthol.